PVC ACCESSORIES

PVC accessories are indicated for making connections and derivations in a network made up of pipes of the same material. These accessories are used in the installation of pressure networks, evacuation, sanitation and systems of drip irrigation.

These components have different connections: glued or threaded. Depending on the type of accessory, the diameters can vary between 20 mm and 400 mm.

When used in circulation systems in which the water moves with high pressure, these parts are very resistant, thus avoiding breakage and continuous maintenance.

The choice of accessory will depend on the type of network in which it will be installed and the pressure with which the water will circulate through these pipes. It is also necessary to properly choose the union they should have. Only in this way can we facilitate the correct joining of the pieces and avoid the loss of water.

For use in pressure, we have elbows, tees, bends, crosses, buttresses, sleeves, terminals, cones, reduction bushings, reduction nuts, threaded reduction, caps, flanges, flange holders and stub axles. All parts are available in a variety of diameters. These accessories are thicker than those intended for purely sanitary use or for sanitation, since water will move through them at high pressures.

For nets intended for sanitary use, we can find elbows, tees, sleeves, bushings, expansion cones, clip grafts and plugs. Depending on the type of part, these are available in different degrees of inclination and diameters.

In sanitation, we have elbows, tees, sleeves, expansion cones, clip grafts and plugs. Similar to pressure and sanitary fittings, PVC fittings for sanitation have different diameters and degrees of inclination.