SOLUTIONS

In Mundoriego you can find a variety of solutions for different purposes, for example:

a) pH electrode storage solutions (230 mL):

Serving to minimize clogging and ensure fast response times, the glass cuvette and electrode junction must always be kept moist.
Most importantly: keep the electrode with a few drops of pH 7 solution or buffer inside the protective sleeve.

b) Electrode cleaning solutions for general use 230mL:

– They serve to maintain the efficiency of the electrode, it is recommended to wash and clean it at the end of the measurement, immersing it in the specific solution for approximately 5 minutes.
– Eliminate all impurities and residues left by the measured samples and in this way, keep the electrode always ready for use.

c) 4 mL pH500 solutions:

– Buffer solutions are produced following precise formulas and standardized with a pH meter calibrated to NIST standards.
– All pH 4 solutions reproduce the lot number, expiration date and the comparison table between pH and temperature.
– They are supplied with the certificate of analysis.
– The use of said buffer for the calibration of reading systems is very common in water control, in purification facilities, in the food sector and in all those applications with a slightly acid unknown pH.

d) 7 mL pH500 solution:

– Buffer solutions are produced following precise formulas and standardized with a pH meter calibrated to NIST standards.
– All pH 4 solutions reproduce the lot number, expiration date and the comparison table between pH and temperature.
-Supplied with the certificate of analysis.

e) CE 12880 micronS/cm 500ml calibration solution.

f) TDS calibration solution 6,44 g/l.