All the irrigation pumps, as can be assumed, are tools that are responsible for supplying the flow of water necessary for the irrigation of our plantations. There are different types and also other details that should be known about them.
Irrigation pumps are devices that supply 'force' so that the flow of water moves where we want it to go. A very interesting feature is that it allows us to determine very precisely the pressure at which we want it to circulate, so control is almost total.
Since these are tools that supply force so that the flow of water moves, we understand that they will need a part that allows them to generate it, such as a motor, for example. So, based on the energy source they use to function, we find different types of irrigation pumps.
Motorbombas
These irrigation pumps use liquid fuels for their operation since they integrate a combustion engine. Generally, the fuel is usually gasoline for those with little power and diesel for those with more.
Electric pumps
These irrigation pumps work by means of a single-phase or three-phase electric motor depending on the power that is required in them.
The preference is always the installation of electropumps because they are cheaper, however, for it to be possible, the land must have an electric current supply, something that does not always occur.
Based on the suction height they have, we also find submersible pumps that are used in reservoirs when the suction height is high; and non-submersible pumps that are installed on the surface of the ground when the suction height is low or non-existent.
Depending on the position of the drive shaft, we also find horizontal irrigation pumps, which are generally used to supply very high flows with low pressures, and vertical pumps that supply water at high pressures.
These are the basic classifications and the main characteristics of the different irrigation pumps. Don't know which one to choose? You have doubts? Contact us and we will advise you on the best solution depending on your specific objectives and the characteristics of the land where you need to install the irrigation pump.
At MUNDORIEGO we are not only a specialist in irrigation pumps, we are specialists in thousands of products such as: pool chemical treatment, pool filter, pool pump y drip irrigation accessoriesWhat are you waiting for? Visit us in MUNDORIEGO.
greetings for a controlled irrigation with 8 diffusers by zones that flow rate or liters per minute my pump should have
Good,
To estimate the required pump, we must know the diffuser model, the installed nozzle, and the nozzle adjustment arc (90º-180º-360º).
Example: estimating the LX diffuser with a 15th nozzle and an average 180º, a total consumption of 8ud x 0.4m³ / h = 3.2m³ / h is estimated at about 3bar of pressure. The most advisable pump would be:
https://mundoriego.es/producto/bomba-e-hmp-1cv-075kw-monofasica-5hm04p07m/
We hope it helps you. All the best.
For an irrigation tape of 100 meters with peaks every 30 cm that deliver 2 liters / h and takes the water from a tank 1,5 meters deep. What pump do I need?
For personal installations, please contact us by writing an email to info@mundoriego.es or our phone +34 655968154.
I need to know what pump or mechanism I need spraying in a cattle tunnel.
For personal budgets, contact us through our email or web phone https://www.mundoriego.es
Good morning, for 2 ha of orange trees, I want direct drip irrigation to each tree, there are 500, what flow and pump would I need, the land is flat but from the well to the trees there is a slope of between 35 or 40 degrees?
We are a store of irrigation equipment, we only supply.
If an installer indicates the necessary material to you after having made a study of your installation, you can send us the material to our email info@mundoriego.es and we will be able to value it for its shipment.